Operating Instructions Administrator Reference
35Configuring the printer
Configure the printer to use the TCP/IP protocol.
•Confirm that the TCP/IP protocol is set to be active. (The factory default is active.)
•Assign an IP address and make other settings required for using the TCP/IP protocol.
Reference
For more information about how to make the above settings, see "Wi ndows XP Configu ration" in
Printer Client Reference that comes with this printer.
If DHCP is used to assign IP addresses, see p.231 “Using DHCP”.
Note
❒After setting the IP address, use the ping command to confirm that it has been set correctly.
AClick [Start], point to [All Programs], point to [Accessories], and then click [Command Prompt].
BType the following: (Example IP address is 192.168.15.16)
C:> ping 192.168.15.16
If the address has been configured correctly, the following message a ppears.

Reply from 192.168.15.16

If the address has been configured incorrectly, the following messag e appears.
Request timed out.