
Operating Instructions Client Reference
125Reference
For more information about how to make the above settings, see “Configuring the prin ter for the
Network” in the Quick Installation Guide.
If DHCP is used to assign IP addresses, see Appendix, “When Using DHCP” in the Administrator
Reference.
Note
❒After setting the IP address, use the ping command to confirm that it has been set correctly.
AClick [Start], point to [Programs], and then click [Command Prompt].
BType the following: (Example IP address is 192.168.15.16)
C:> ping 192.168.15.16
If the address has been configured correctly, the following message appear s.
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address has been configured incorrectly, the following message ap pears.
Request timed out.Request timed out.
❖
❖❖
❖Configuring a Windows NT 4.0 computerFollow these steps to configure a Windows NT 4.0 computer to use the TCP/IP protocol.
AOpen [Control Panel] and double-click the [Network] icon. Confirm that “TCP/IP Protocol” is
listed in the [Network protocols] box under the [Protocols] tab.
Note
❒If the TCP/IP protocol is not installed, click [Add] under the [Protocols] tab and install i t. For
more information about installing the TCP/IP protocol, see Windows NT 4.0 Help.
BConfigure the TCP/IP protocols with the appropriate IP address, subnet mask and ot her se ttin gs.
Confirm that the settings are correct with the network administrator.