Operating Instructions Client Reference
92
Reference
For more information about how to make the above settings, see Configuring the prin ter for the
Network in the Quick Installation Guide.
If DHCP is used to assign IP addresses, see Appendix, When Using DHCP in the Administrator
Reference.
To use the IP over 1394, see the Option Setup Guide.
Note
After setting the IP address, use the ping command to confirm that it has been set correctly.
AClick [Start], point to [All Programs], point to [Accessories], and then click [Command Prompt].
BType the following: (Example IP address is 192.168.15.16)
C:> ping 192.168.15.16
If the address has been configured correctly, the following message appear s.
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address has been configured incorrectly, the following message ap pears.
Request timed out.
Configuring a Windows XP computer
Follow these steps to configure a Windows XP computer to use the TCP/IP protocol.
AClick [Start] on the taskbar, point to [Control Panel], and then click [Network and Internet Con-
nections].
BClick [Local Area Connection].
COn the [File] menu, click [Properties].
Note
With the IP over 1394, click [1394 Connection].