Runco VX-6000D Installing and Adjusting the CineWide Anamorphic Lens, Assembly to Lens Motor

Installation

3.10 Installing and Adjusting the CineWide Anamorphic Lens

If you are installing a CineWide-equipped projector, proceed as follows to install and adjust the anamorphic lens.

It is extremely important that the primary lens is properly

Note adjusted before you install the anamorphic lens. Ensure that the image from the primary lens is perfectly centered on the screen.

Attach Lens Mounting ➤	The VX-6000d Anamorphic lens mount kit consists of everything shown in Figure 3-18.
Assembly to Lens Motor	Some components shipped with your projector may differ slightly from what is shown in
Carriage Plate (CineWide	these instructions. If any items are missing or damaged, please contact your Runco dealer
with AutoScope) or Base	or Runco Customer Service at (800) 23-RUNCO.
Plate (fixed CineWide)

1 Lens Adapter Ring

2 Pitch Adjustment Yoke for Lens

3 Height/Y Adjustment

T-Screw (2x)

and Washer (2x)

4 Pitch Adjustment

T-Screw (2x)

and Washer (2x)

8Yaw/X Adjustment

Levers (2x) and	5 Anamorphic Lens
Washers (2x)	Holder
	6 1/4-20 Hex Bolts (2x)

7 AutoScope Carriage Plate

Figure 3-18. VX-6000d Anamorphic Lens Mounting Assembly - Exploded View

1.Remove the two Yaw/X Adjustment Levers and 1/4-20 Fiber Washers (item #8) from the bottom of the Anamorphic Lens Holder (item #5).

2.Place the Anamorphic Lens Holder on top of the AutoScope Carriage Plate or fixed CineWide base plate (item #7). Position the bracket so that the long slot at the bottom of the lens holder is perpendicular to the corresponding slots on the carriage plate or base plate.

3.Secure the Anamorphic Lens Holder to the plate using the Hex Bolts (item #6), Yaw/X Adjustment Levers and Washers that you removed in Step 1.

42 Runco VX-6000d Owner’s Operating Manual