Runco VX-6000D Always set this option to On. Doing otherwise may disrupt, Runco Technical Support

Operation

Power Save: Select Power Save from the Options menu to access the power management features of the VX-6000d.

•RS-232C Port: When this option is set to On, the RS-232 port is always active and consuming power, even when the projector is in standby mode. When set to Off, the RS-232 port is inactive and does not consume power when the projector is in standby mode.

Always set this option to On. Doing otherwise may disrupt

Caution communication between the projector and DHD Controller.

•Auto Power Off: When this option is set to On, the projector enters standby mode after 15 minutes of inactivity (no input signal). Five minutes before this is to occur, the message “Enter STANDBY mode in 5 min.” appears on-screen. This message updates to indicate the amount of time before the projector enters standby mode.

When set to Off, the projector remains in the “power on” state regardless of the presence or absence of an input signal.

Note	When you set the Auto Power Off function to Off, the LED function
	(refer to LED on page 71) is automatically set to On.

Baud Rate: Select Baud Rate from the Options menu, then press the or button to select the projector’s RS-232 baud rate. This function is used to change the transfer rate of the RS-232 connection between the projector and the DHD Controller. The default setting is 9600 bps. Do not change it unless specifically instructed to do so by

Runco Technical Support.

Fan Mode: If the projector is being used in a high-altitude environment, use the Fan Mode control to prevent it from overheating. Set it to High Altitude (2) to run the fan at high speed; set it to Normal (1) to run the fan at normal speed.

Orientation: Refer to Adjusting the Picture Orientation on page 40.

Factory Default: To reset all projector settings (including image settings) back to their factory defaults, choose Factory Default from the Options menu. When the confirmation message appears, select All Reset to perform the reset or Return to cancel. This action is not undoable. Proceed with caution!

Note	The Factory Default command does not reset the Lamp Timer or
	OSD Language setting.

72 Runco VX-6000d Owner’s Operating Manual