Installation

Adjusting the Yaw: Loosen the Yaw/X-Adjustment Levers to allow the lens to pivot freely from side to side. Then, angle the lens to even out any left-right pincushion distortion:

Anamorphic Lens (Top View)

Wrong Position

Correct Position

Once the proper lens angle has been set, firmly tighten the Yaw/X-Adjustment Levers to secure the lens in place.

Adjusting the Geometry:

1.Input an anamorphic cross-hatch test pattern to the projector.

2.Loosen the three Lens Rotation Set Screws (shown in Figure 3-19)on the lens adapter ring just enough to allow it to rotate freely.

3.Grasp the lens by the front ring and rotate the lens until the image is properly anamorphic:

Wrong Position

Correct Position

4.When the image geometry appears correct, tighten the three Lens Rotation Set Screws to secure the lens in place. (When viewed from the front, the rear opening on the anamorphic lens should appear as a tall, narrow oval.)

46

Runco VX-6000d Owner’s Operating Manual

Page 58
Image 58
Runco VX-6000D manual Anamorphic Lens Top View, Adjusting the Geometry