Samsung SL-C460FW/XAA Message Meaning Suggested solutions Calibrating, Image density…, Door Open

Understanding display messages

Message	Meaning	Suggested solutions
Calibrating	The machine is calibrating	Wait a few minutes.
image density…	the image density.
Door Open	The cover is not securely	Close the cover until it
Close it	latched.	locks into place.
Scan Unit Open	The scan unit is not securely	• Clear the jam (see
or Exit JAM	latched or paper has	"Clearing original
	jammed in the scanner area.	document jams" on
		page 95).
		• Close the cover until it
		locks into place.
Door of scanner is	The cover of scanner is not	Close the cover until it
open.	securely latched.	locks into place.
Error [error number]	The indicated toner	Reinstall the Samsung-
Install [color] toner	cartridge is installed	genuine toner cartridge
	improperly, or the connector	two or three times to
	is polluted.	confirm it is seated
		properly. Or clean the
		connector. If the problem
		persists, contact the
		service representatives.
Error [error number]	The machine unit cannot be	Reboot the power and try
Turn off then on	controlled.	the printing job again. If
		the problem persists,
Error [error number]
		please call for service.
Call for service

Message	Meaning	Suggested solutions
Scanner Locked	The scanner is locked.	Reboot the power. If the
		problem persists, please
		call for service.
Install TR.	The transfer belt is not	Install a Samsung-
belt unit.	installed.	genuine transfer belt.
Not compatible	The transfer belt of the	Install the a Samsung-
transfer belt	machine is not for your	genuine part designed
	machine.	for your machine.
Not installed	The waste toner container is	Install a Samsung-
Waste tank	not installed.	genuine waste toner
		container.
Check Fax Line	The fax line is not properly	Connect the fax line to
	connected to the LINE port.	the LINE port not to the
		EXT port (see "Rear view"
		on page 23).
Not proper room	The machine is in a room	Move the machine to a
temp. Move set	with improper room	room with proper room
	temperature.	temperature.
Output bin Full	The output tray is full. Or the	Remove papers from the
Remove paper	sensor is not facing down.	output tray, the machine
		resumes printing. Or
		make sure the sensor is
		facing down. If the
		problem persists, call for
		service.

4. Troubleshooting 110