Samsung SMT-190Dx user manual Night Vision Camera, Mode, Connect the camera cable to the camera

USER'S MANUAL

• Adjust the camera to target the video location and tighten the bracket handle on the camera mount bracket. Install the camera on to the

male screw of the Camera Mount Bracket by rotating the camera in clockwise.

Connection status checking method :

• Turn on the monitor after connecting cameras,

and check if camera image is displayed. The initial screen mode of monitor is quad

mode.

• In case monitor and camera is not connected, OSD ‘L’(LOSS) will be displayed on screen.

•Loosen the handle by turning it in counter clockwise direction and then adjust the camera position. Tighten the handle, turning it clock wise, and lock the camera in position.

•Connect the camera cable to the camera.

Handle

After positioning monitor and installing four cameras to a desired location, please connect CAMERA to MONITOR through CAMERA CABLE (MCB-60) as shown in the below figure. Please check whether or not it is properly connected.

2-4) Night Vision Camera

1)Before Installation

SOC-N120 INTRODUCTION

SOC-N120 Night Vision camera is intended to be used exclusively with those sold by this company for DIY. With the built-in IR LED and light sensor in the camera, both day monitoring and night moni- toring are possible. Also, since it is designed as weather-proof daily product, it can be used not only indoors, but also outdoors.

2)Precautions for Installation and Operation Installing SOC-N120

Make sure the installation location is a place where it can tolerate 5 times of the total weight of the camera before installing.

When installing the camera, make sure the cable is not squeezed in an inappropriate place or the insulation plastic is removed (it will be a cause for malfunction or fire).

Eng-10