Samsung SMT-190Dx user manual System Setup

USER'S MANUAL

5-8) SYSTEM SETUP

	07/07/07	00:00:01
SYSTEM SETUP
PASSWORD	********
PASSWORD LOCK	OFF
RECORD LOCK	OFF
HDD ERASE	OFF
FACTORY RESET	OFF
SYSTEM ID	1
1CH RECORD SUPPORT	OFF
LANGUAGE	ENGLISH

1.PASSWORD

The default password: 4321

-You can set the password to limit unauthorized access to the Main Screen setup menu.

(Create a eight-digit password by choosing between 1~8.)

You can enter the password using the corresponding channel key.

2.PASSWORD LOCK

-If PASSWORD LOCK is set after you assigned a PASSWORD, you must enter PASSWORD each time you enter to MENU. [ON/OFF]

-Use , , , , key to make changes.

-Use a 1 to 8 digits alphanumeric key to enter PASSWORD and press the OK key using the / key.

-If your PASSWORD is mismatched 3 times or more the display is moved to MULTI screen.

-"PASSWORD FAIL" is displayed when your password is mismatched or when you enter 4 digit more password.

3.RECORD LOCK

If you set RECORD LOCK to ON and press STOP to release the current recording, you are prompted to enter the PASSWORD. [ON/OFF]

4.HDD ERASE

If you set HDD ERASE to ON, you will see a message of "SYSTEM HDD ERASE?" that asks if you want to erase the data on the HDD. If you click OK, you'll see "HDD ERASE" as in the next picture, and the existing HDD Data is erased. If you click CANCEL, the HDD data will not be erased.

If you erase HDD, system will reboot and format HDD automatically. It takes about 2 minutes to format. [ON/OFF]

Caution

Deleted data cannot be restored. Check data carefully again before deleting.

5.FACTORY RESET

When FACTORY RESET is performed, the setup value will factory default setting when initialization starts.

1.Select SYSTEM SETUP from MENU screen. 2.From the SYSTEM SETUP submenu, set FACTORY

RESET to ON.

3.When you exit MENU, the phrase “FACTORY RESET” appears on the monitor and the initialization starts. [ON/OFF]

-Use , , , , key to make changes.

6.SYSTEM ID

Set the System ID to use the Remote Controller. When using more than one unit of the system, a number of systems may be operated at the same time with a single remote controller. Set the different IDs for different units. Press the System ID of the Remote Controller and use the number keys to create IDs. After the setting, systems with IDs that correspond to the ID of the remote controller will operate.

[0,1,2 ~ 8,9]

Note

You must set the same SYSTEM ID of the DVR menu and LCD menu to use system ID function. and set the same SYSTEM ID for the remote controller too.

If the SYSTEM ID of the DVR menu is differ from the LCD menu's, the remote controller may not operate properly. Set the SYSTEM ID of the LCD menu at LCD menu > Setup Menu > System ID.

Press the number button that you want on the remote controller while SYSTEM ID button is pressed for set- ting the SYSTEM ID of the remote controller.

7.1CH RECORD SUPPORT

If you set 1CH RECORD SUPPORT to ON, the system switches from 8-channel to 1-channel mode. Then, the number 1 channel will be selected.

If you set 1 CH RECORD SUPPORT to ON, you will see a message of "SYSTEM CHANGE 1CH DVR?" that asks if you want to change the SYSTEM into 1 channel mode. If you click OK, the system switches. Once the system switched to 1 channel mode, all system functions operate in 1 Channel mode and the items of other channels in the MENU are deactivated.

Once the system switched to 1 channel mode, you can just play the data in this mode and the data recorded in 8 Channel mode could not be played.

Eng-23