Samsung SMT-190Dx user manual Archive Setup, System Information

USER'S MANUAL

Caution

In cases where the PC's DNS server address is not set and the connection using domain name is not available, Please consult your network administrator to set DNS server address.

Caution

The connection to SMT-190DN is unavailable for about 2~5 minutes after powering on your DSL Modem. Since the connection is not available, as the IP is not received from DSL communications, please reboot by turning off the power of DSL Modem and SMT-190DN for more than 5 seconds, and then try to connect again.

5-10) ARCHIVE SETUP

The initial setup status of ARCHIVE SETUP menu is shown below.

	07/07/07	00:00:01
ARCHIVE SETUP
ARCHIVE ENABLE	ON
DATE (YY / MM / DD)	05 / 01 /05
TIME (HH : MM : SS)	00: 00 : 01
ARCHIVE CH	CH1
ARCHIVE UNIT	1MB
ARCHIVE FORMAT	OFF

[ 8MB / 249MB ][ ARCHIVE START ]

USAGE : USB MEMORY STICK

from the selected date and time of the selected channel. [1MB, 2MB, 3MB]

-Use , , , , key to make changes.

6.[ARCHIVE START]

-If press ENTER KEY after moving cursor to " [ARCHIVE START]", DATA ARCHIVE begins.

7.[8MB/249MB]

-If user uses 256 MB USB MEMORY STICK and stores 8 MB of DATA to USB MEMORY STICK, "[8MB/249MB]" is displayed.

"8MB" is used capacity and "249MB" is total USB capacity.

External USB

-The compatible USBs are as follows.

Mark	Model Name	Capacity
AL Tech	AnyDrive	256MB, 512MB
SanDisk	Cruzer Mini	256MB, 512MB
GeekSquad	GeekSquad	256MB, 512MB

Caution

The only supported USB DEVICE is a USB MEMORY STICK.

1. ARCHIVE ENABLE		5-11) SYSTEM INFORMATION
- If you would like to move HDD DATA to USB memory		This initial setup status of SYSTEM INFORMATION
stick, set the ARCHIVE ENABLE to ON.		menu is shown below.
- This is the USB MODE and you can't record a
picture to HDD. You must set the ARCHIVE ENABLE
				07/07/07 00:00:01
to OFF for recording a picture to HDD. [ON/OFF]			SYSTEM INFORMATION
			CAPACITY	0/250GB
2. DATE (YY/MM/DD)			VERSION	SMT-190 1.0
- Set the date that you want to save data to USB.			CAPACITY : USED SIZE/TOTAL SIZE
- Use , , , ,	key to make changes.
3. TIME (HH:MM:SS)
- Select a time you would like to back up your data		1. CAPACITY
from.
- Use , , , ,	key to make changes.	- Shows HDD capacity of the system. USED SIZE/
4. ARCHIVE CH		Total HDD capacity
		2. VERSION
- Set the channel that you want to save data to USB.
[CH1, CH2, CH3, CH4, CH5, CH6, CH7, CH8]		- Shows system version.

-Use , , , , key to make changes.

5.ARCHIVE UNIT

-Set the data capacity unit that you want to save data to USB.

If you select 1MB, data will be stored up to 1MB

Eng-27