Samsung SMT-190Dx Dwell Time Setup, Alarm Setup, Event Record Mode, Event Record Enable

USER'S MANUAL

5-4) DWELL TIME SETUP

The initial setup status of DWELL TIME SETUP menu is shown below.

	07/07/07	12:30:01
DWELL TIME SETUP
CAM1	03 SEC
CAM2	03 SEC
CAM3	03 SEC
CAM4	03 SEC
CAM5	03 SEC
CAM6	03 SEC
CAM7	03 SEC
CAM8	03 SEC
QUAD-A	03 SEC
QUAD-B	03 SEC

1.DWELL TIME SETUP

-Pressing SEQUENCE button in Single Screen will bring up the SEQUENCE MODE. You may set the time display for each channel. If you set zero (0) seconds as the DWELL TIME for a particular channel, the set channel will be skipped and next channel will be shown. You may set time in the QUAD-A, QUAD-B screens.

[0SEC, 1SEC, 2SEC, 3SEC.................... ~ 60SEC]

-Use , , , , key to make changes.

5-5) ALARM SETUP

•Function: Allow users to set the ALARM MODE for each camera.

•Setting method: Move to ALARM SETUP MENU by using /KEY in the SETUP MENU, and press the ENTER SWITCH to display the OSD as shown in the figure below. (The figure shows the initial setting status.)

	07/07/07	00:00:01
ALARM SETTING
CAMERA1	ON
CAMERA2	ON
CAMERA3	ON
CAMERA4	ON
CAMERA5	ON
CAMERA6	ON
CAMERA7	ON
CAMERA8	ON
HOLD TIME	05SEC
ALARM ON TIME	00:00
ALARM OFF TIME	00:00
ALARM TONE	ON

(1)CAM1 to CAM8 item sets whether the alarm sensor connected to the camera is used or not.

(ON: Alarm function setting, OFF: Alarm function canceling)

(2)HOLD TIME item sets time to freeze alarm operation when alarm occurs.

(HOLD TIME to be set: 05SEC ~ 1MIN ~ 30MIN)

Note

If you want to carry out the alarm operation, you must preset ALARM ON/OFF TIME in monitor before CAMERA ALARM is set to ON.

(3)ALARM TONE sets whether or not alarm tone (high-pitched tone)sounds when an ALARM occurs. (ON: ALARM TONE operation, OFF: Cancel)

5-6) EVENT RECORD MODE

The initial setup status of EVEVT RECORD SETUP menu is shown below.

07/07/07 00:00:01

EVENT RECORD SEUTP

EVENT RECORD ENABLE	OFF
PRE ALARM TIME LIMIT	0 SEC
POST ALARM TIME LIMIT	1 MIN
MOTION DETECTION	OFF
SENSITIVITY	NORMAL
MOTION CH SETUP...

1.EVENT RECORD ENABLE

If you want to start recording when Alarm goes off, then select ON. If you do not want to start recording when Alarm goes off, then select OFF. If you set EVENT RECORD ENABLE to ON and exit the menu, system starts recording whenever Alarm is activated. The following screen shows that ALARM recording is in progress when ALARM is activated.

It shows the ALARM for Channel 4 is activated with a "A" mark. [ON/OFF]

	07/01/05	00:00:01
CAM1	CAM2	CAM3
A CAM4	CAM5	CAM6
CAM7	CAM8

Eng-21