LIVE settings

E

2Select the setting position (4 positions) using the control button (}~).

3Select the input terminal number (1 - 16) using the control button ({).

In DSR-2108, input terminal number (1 - 8).

4Press the ENTER button.

Setting the VIDEO LOSS ON

An alarm signal is output when the specified video input terminal receives a VIDEO LOSS occurs.

1Select "VIDEO LOSS ON" using the control button ({).

2Select the setting position (4 positions) using the control button (}~).

3Select the input terminal number (1 - 16) using the control button (}~).

In DSR-2108, input terminal number (1 - 8).

4Press the ENTER button.

Setting the HDD ERROR

An alarm signal is output when a hard disk error occurs.

1Select "HDD ERROR" using the control button ({).

2Select output ON or OFF using the control button (}~).

Setting the ALARM DURATION

Sets the duration of the alarm output signal.

1Select "ALARM DURATION" using the control button ({).

2Select the output duration (3 - 255 seconds) using the control button (}~).

4Select "ALARM IN NO." using the control button

({) and specify the alarm input terminal number (1-16) using the control button (}~).

Setting the signal polarity of the specified alarm input terminal.

In DSR-2108, input terminal number (1 - 8).

Setting the TYPE

1Select "TYPE" using the control button ({).

2Set the signal polarity using the control button (}~).

---:Does not react

N/OPEN (Normal Open): Normally open, reacts when closed

N/CLOSE (Normal Close):

Normally closed, reacts when opened

FSetting the MON2 (Monitor2)-OUT

Sets the output conditions of the monitor video terminal (MON2).

1Select "MON2-OUT" using the control button ({) and press the ENTER button.

The MON2-OUT screen is displayed.

MON2-OUT

MON2 TYPE

FULL

MON2 ON EVENT

ON

MON2 EVENT DWELL TIME

10 SEC

SEQUENCE

OFF

SEQUENCE-DWELL TIME

10 SEC

MON2 CHANNEL

1

2Setting the output conditions of the MON2 terminal

Setting the MON2 TYPE

Sets the output screen layout of the MON2 terminal.

1Select "MON2 TYPE" using the control button ({).

2Select the screen layout using the control button (}~). FULL: Single-screen output

QUAD: Quad-screen output

Setting the MON2 ON EVENT

Sets whether the video of an event is output to the MON2 terminal while it is being recorded.

1Select "MON2 ON EVENT" using the control button ({).

2Select ON or OFF using the control button (}~). ON: The video of the event is output.

OFF: The video of the event is not output.

Setting the MON2 EVENT DWELL TIME

If "MON2 ON EVENT" is set to ON, set the output duration of the video of the event.

1Select "MON2 EVENT DWELL TIME" using the control button ({).

2Set the output duration (1 - 10 seconds) using the control button (}~).

33

Page 40
Image 40
Sanyo DSR-2108 Setting the Video Loss on, Setting the HDD Error, Setting the Alarm Duration, Setting the Type