Record settings Record, Disk settings Disk | Sanyo DSR-2108 specification

Setup menu settings

ERecord settings (Record)

Sets the recording conditions while in network operations. Recorded video is saved on the hard disk of the PC.

1Record Condition

Select a recording mode using the radio button.

•Always:

Recording is performed when the recording button on the operation panel is set to ON.

•Event:

When the recording button on the operation panel is set to ON, recording is on standby and recording is performed when specified events occur.

<Automatic recording settings (Auto Record)>

If the checkbox is checked, the recording button on the operation panel is set to ON and video is automatically recorded in the selected recording mode only after you launch the DVR Utility 2000S the next time.

[Auto Record] settings become valid as soon as the unit has been disconnected and reconnected.

2Event

If [Record Condition] is set to "Event", set the following conditions.

•Motion:

When this unit performs a MOTION recording the event is also recorded on the PC.

•Alarm:

When an alarm signal is input into the external sensor terminal situated on the back panel of this unit, the event is recorded on the PC.

<Recording duration>

• Duration (Unit: seconds)

3Channel

Specify the camera to be recorded using the checkbox.

Memo: Using "All" of the checkbox, the user can check or uncheck all the cameras.

Click [OK] once the above settings are complete. The content of the settings are confirmed and saved.

FDisk settings (Disk)

Set the capacity and the drive of the PC where the recorded video is saved.

1Disk Space

Select the drive used for saving and input the allowable capacity (MB).

2Disk Full

Select the option once the capacity is exceeded using the radio button.

•Replace oldest files:

Continues to record and overwrites the previously recorded video starting with the oldest.

•Stop recording: Stops the recording.