Sanyo DSR-2108 Pre-operation preparation, BExample of multi-16 screen, BExample of single-screen

Pre-operation preparation

Screen display

Upon turning the power on, live video is displayed in the multi screen format.

• The screen display can be hidden except for the recording screen display. (P31)

bExample of multi-16 screen

1	2 34				5			6
		:A				2%	2009/05/03 09:04:54
CH1			CH2			CH3			CH4
				C
CH5			CH6			CH7			CH8
CH9			CH10			CH11			CH12
CH13			CH14			CH15			CH16

7 8

1Operation display

: Displayed during live video sequencing.

: Displayed during alarm output.

: Displayed when the alarm output is set to DISABLE. : Displayed during remote operation by PC.

2Remote control display (P41)

:A : Displays the remote control ID currently in operation.

If no remote ID is set the message "A(all)" is displayed.

3Alarm input display

: Turns red during an alarm recording triggered by motion or external alarm input (ALARM IN).

4Security lock display

: Displayed when setting the security lock. (P28)

5Hard disk used capacity display

Displays the amount of recording on the hard disk from

0-99%. When the disk is full, "99%" changes to "FULL".

When the recording setting is set to overwriting and the

hard disk is full, to the left of the capacity display lights to indicate that the unit is in the overwriting mode.

bExample of single-screen

1	2 34		5	6
		:A		2%	2009/05/03 09:04:54

CH1 C

7 8

6Date and time display

This unit manages the recorded videos according to their date and time. Make sure the correct date and time are set in the CLOCK SET. (P9)

7Camera channel display

Select display/hide channel in "OSD" in "LIVE settings". (P31)

8Recording display

Factory default settings start continuous recordings (C) automatically once the power is turned on. Change the recording mode using the menu settings. (P35)

C:Recording in the continuous mode (CONTINUOUS)

R:Recording in the real time mode (When pressing the REC/STOP button)

M:Recording in the motion detection mode (MOTION)

A:Recording in the ALARM IN detection mode (ALARM)

•If a live video is disconnected, the message "VIDEO LOSS" is displayed on the monitor.

•If a video signal is not connected to the video input terminal, the message "NO VIDEO" is displayed on the monitor.

8