Sanyo DSR-2108 Setting the NTP, Setting the Storage, Return Mail Address, Ntp Use

Remote Setup

JSetting the Send E-Mail

This sub menu is accessible from the Network settings.

This setting is used to automatically send a notification e-mail to a specified address when an alarm occurs, for example.

The DVR will be forcibly restarted if a value on this screen is changed.

1

2

3

4

5

6

1Send E-mail

•ON: E-mail sending function enabled

•OFF: E-mail sending function disabled

2IP Notification

To send a notification e-mail when the DVR IP address is changed, check the checkbox.

3Event Alarm

The alarm event type can be used as condition for sending notification e-mails.

•OFF (factory default)

Notification e-mail is not sent even if an alarm is detected.

•ALARM

A notification e-mail is sent when ALARM recording is triggered by the sensor connected to the external alarm input terminal (ALARM IN) of the unit.

•MOTION

A notification e-mail is sent when MOTION recording is triggered by a movement detected by the motion sensor built into the unit.

•ALL

A notification e-mail is sent when a recording is triggered either by an external alarm or the built-in motion sensor.

Memo: Alarm notification requires setting of ALARM-SET. (P32)

4Mail Address

Input the destination address.

5Mail Server settings

Input the SMTP server name as well as the user ID and password.

6RETURN MAIL ADDRESS

Set the source e-mail address to be notified to the destination.

KSetting the NTP

Allows synchronizing the time using an internet or LAN NTP server.

1

2

3

4

5

1NTP USE

•ON: Synchronize using NTP server

•OFF: Do not synchronize using NTP server

2NTP Primary Server Address

Input the NTP primary server address.

3NTP Secondary Server Address

Input the NTP secondary server address.

4Time Zone

Select the time zone.

(GMT -1:00 to -12:00, GMT 0:00 to 13:00)

5Interval

Set the time to synchronize. (01 - 24:00)

LSetting the Storage

Allows to configure continued recording settings by overwriting the hard disk and the storage period for the recording data.

1

2

3

1Overwrite

To continue recording by overwriting when the hard disk becomes full, check the checkbox.

2Auto Delete

•ON: Auto-delete function enabled

•OFF: Auto-delete function disabled

3Auto Delete Days

If auto-delete is set to ON, set a recording data storage period.

(2/3/4 - 60 DAYS)

75