Network Camera (Wired LAN) Settings
3 NETWORK SET Settings
These settings are used in order to connect the camera to the network. After these settings have been completed, you may also have to make wireless LAN settings or PPP settings. More than one camera can be connected to the same network, but in order to do this, you will need to make settings for each camera such as assigning separate IP addresses before connecting the cameras to the network.
1
2
3
4
5
6
7
☞Click the [NETWORK] menu select button.
The NETWORK SET screen will be displayed, and the default settings for each item will be displayed automatically.
Once you have completed making the settings, click the [SET] button.
Note: Check with the network system administrator or Internet Service Provider if you need to change the IP address 1, subnet mask 2 or gateway 3 settings.
4Set the password.
There are three access levels available (User, Operator and Administrator) and separate passwords can be set for each level. The factory default settings are shown in Table 1 (p. 23), and the range of operations varies as indicated for each access level.
Note: It is recommended that you change the passwords whenever possible for security purposes. (p. 21)
Default settings displayed
Reset if necessary
5NETWORK SPEED
This sets the speed of data transmission by the camera.
Available settings:
64, 128, 256, 512, 1024 (Kbps), NO LIMIT (Default setting: No limit for transmission speed)
6HTTP PORT NUMBER (default setting: 80)
This setting is used when more than one camera is connected to a broadband router and a single IP address for that router is being used to make the images being monitored by the camera publicly available over the Internet. Refer to the documentation provided with the broadband router for further details.
Normally the HTTP PORT NUMBER setting should be left “80” without being changed, even if more than one camera is connected to the network.
– 20 – | English |
