CAMERA Settings
1MODE
This sets the DAY/NIGHT mode.
Item | Operation after selection | Required settings | |
AUTO (p. 29) | Monitoring switches automatically between | 2 AGC Gain | |
color and black & white depending on the | 4 LEVEL | ||
| luminance of the objects. | 6 BURST | |
| Images are monitored in color regardless | 2 AGC Gain | |
COLOR (p. 29) | of the luminance of the objects. In addition, | 3 ALARM OUT | |
devices such as an infrared sensor can be | 5 POLARITY | ||
| used to externally switch between color | 6 BURST | |
| and black & white. |
| |
B/W (p. 30) | Images are monitored in black & white | 2 AGC Gain | |
regardless of the luminance of the objects. |
| ||
|
| ||
| Monitoring can be switched between color | 2 AGC Gain | |
TIMER (p. 30) | and black & white after the length of time | 3 ALARM OUT | |
specified. | 6 BURST | ||
| |||
|
| 7 TIMER | |
|
|
|
2AGC Gain
If the objects are dark, set the AGC Gain to the maximum value so that images are made brighter when they are being monitored. The AGC Gain can be set separately for each mode.
Available settings:
•AUTO: +9dB (default setting), +12dB, +15dB
•COLOR:
•B/W:
•TIMER: +9dB (default setting), +12dB, +15dB, OFF (AGC is not used)
Note: When the AGC gain is increased, sensitivity will also be increased for dark objects and they will appear bright, but interference will also increase.
3ALARM OUT (Set when using COLOR and TIMER mode)
When an IR lamp or similar device is connected to the ALARM OUT terminal at the rear of the camera, the IR lamp can be made to illuminate when the mode switches from color to black & white.
Available settings: OFF, NC, NO
4LEVEL (Set when using AUTO mode)
This sets the luminance for switching automatically between color and black & white.
Available settings: LOW, MID (default setting), HIGH (switching at brighter luminances)
5POLARITY (Set when using COLOR mode)
This sets the input polarity for the D/N IN terminal at the rear of the camera. When a device such as an infrared sensor is connected to the D/N IN terminal, it can be used for forcibly switch from color to black & white.
Available settings: NC, NO
6BURST
This sets the color burst for MONITOR OUT connector image signals. Sometimes distortion can occur when the mode switches from color to black & white depending on the connection. If this happens, change this setting to “ON”.
Available settings: OFF, ON
7TIMER (Set when using TIMER mode)
Set the time for switching from color to black & white from the
Available settings:
•ON: When the set time is reached, monitoring changes to black & white (Default setting: 18:00)
•OFF: When the set time is reached, monitoring changes to color (Default setting: 6:00)
Note: Settings that overlap a day can also be made.
– 28 – | English |
