PPP (Dial-up) Settings
☞DIAL TO PROVIDER Settings
1 Click the [PPP] menu select button.
2 Select “USE” from the “DIAL TO PROVIDER”
The PPP SET (TO PROVIDER) screen will be displayed.
3 Set the following items for connecting to the access point.
•PROVIDER TEL. NO.:
If you need to dial “0” first, type in the number as
•LOGIN ID: Type in your user ID for the provider.
•PASSWORD: Type in your password for the provider.
3
4
4 Select the authentication settings
(AUTHENTICATION).
This sets the authentication protocol to be used when connecting to the access point. Set this to the protocol specified by the Internet Service Provider. It should normally be set to “AUTO”.
Available settings:
•AUTO (default setting): PAP or CHAP is chosen automatically as required
•PAP: Only PAP authentication is used.
•CHAP: Only CHAP authentication is used.
5 IP address and error display
1AUTO IP ADDRESS: The IP address is only displayed while the camera is connected.
2ERROR INFO.: Shows the most recent error information during a PPP connection.
Display details:
•Modem timeout or Not connected
•Line connection error
•Line disconnected
•PPP connection error
•PPP authentication error
•PPP connected and disconnected normally
6 Click the [SET] button.
The PPP SET screen will be displayed.
7 Select the type of telephone line (CIRCUIT TYPE).
This sets the type of telephone circuit that the modem is connecting to.
Available settings:
•TONE: For tone dialing circuits
•PULSE: For pulse dialing circuits
Note: Set to “TONE” if using a terminal adapter.
8 Type in any AT commands that are required to control the modem.
Type in “AT” at the beginning, and then type in the commands specified by the modem manufacturer followed by a command to change flow control to software control.
– 56 – | English |
