GENERAL PROGRAMS

Key operator code change

This program is used to change the key operator code that must be entered to configure the key operator programs. When the machine is first used, the key operator should change the key operator code that was set at the factory to the desired 5-digit code. Only one key operator code can be programmed.

The factory default setting for the key operator code is 00000.

Product key

Use these programs to enter the product keys for the following options.

PS3 expansion kit

This program is used to enter the product key for the PS3 expansion kit (this allows the machine to be used as a PostScript compatible printer).

Ask your dealer for the product key.

Network scanner expansion kit

This program is used to enter the product key for the network scanner expansion kit.

Ask your dealer for the product key.

E-mail alert and status

This program is used to enter the product key for E-MAIL ALERT AND STATUS, which enables customer product support via a network system.

Ask your dealer for the product key.

Serial number

This program is used to check the serial number of the machine.

Initialize and/or store settings

These programs are used to return the key operator programs to the factory default settings, to store the current key operator program settings, and to restore stored key operator program settings. (Note that this also includes printer configuration settings.)

The following programs are available:

●Restore factory defaults

●Store current configuration

●Restore configuration

Restore factory defaults*1

This program is used to return the key operator program settings (including the printer configuration settings) to the factory default settings. If you need a record of the settings prior to restoration of the default settings, print the key operator program list "List print" (page 12).

NOTE

After this program is set, exit the key operator program, turn off the power switch, and then turn on the power switch again after at least 3 seconds. The program will be effective at this time.

Store current configuration*1

This program is used to return the key operator program settings (including the printer configuration settings) to the factory default settings. The stored settings will remain in memory even if the power switch is turned off. To read the stored settings, use the following "Restore configuration" program.

Restore configuration*1

This program is used to read the configuration that was stored using the "Store current configuration" program and restore it as the current configuration.

The currently set configuration will change to the configuration read from memory.

NOTE

A confirmation message will appear at the end of the setting procedure of programs marked by *1. If you need to cancel execution of the program, touch the [NO] key.

13