Sharp ER-A347 Also the UPC codes are printed in the sequence shown below, Report type, Op X/Z

	Report type	Description	Operating modes			Data to be entered
			OP X/Z	X1/Z1	X2/Z2
GENERAL		General report		X1, Z1	X2, Z2
<DEPT. MENU>
						Department code
	BY RANGE	Department by group report		X1	X2	(The range can be
						specified by entering
						start and end codes.)
	BY GROUP	Individual department group		X1	X2	Department group no. (1
		report				to 12)
	GROUP TOTAL	Department group total		X1	X2
		report
<TRANS. MENU>
	TRANSACTION	Transaction report		X1	X2
	TL-ID	Total-in-drawer report		X1	X2
<PLU/UPC MENU>
						PLU/UPC code
	BY RANGE	PLU/UPC sales report by		X1, Z1	X2, Z2	(The range can be
		specified range				specified by entering
						start and end codes.)
	BY DEPT	PLU/UPC report by		X1, Z1	X2, Z2	Department code
		associated department
<CLERK MENU>
	ALL CLERK	All clerk report		X1, Z1	X2, Z2
	IND. CLERK	Individual clerk report	X, Z	X1, Z1	X2, Z2	For the assigned clerk
						For an individual time
	HOURLY	Hourly report (all or by		X1		range (The range can
		specified range)				be specified by entering
						start and end times.)
		Hourly report (all)		Z1
	DAILY NET	Daily net report			X2, Z2
	SRM REPORT	SRM (Sales Recording			X2	Only for the Quebec
		Module) report				fiscal

NOTE The following reports relating to PLU/UPC is issued in the sequence of PLUs and UPCs. PLU/UPC and PLU/UPC BY DEPT.

Also the UPC codes are printed in the sequence shown below.

EAN-13

EAN-8

UPC-A

UPC-E

ITF-14

39