![](/images/new-backgrounds/1169473/16947353x1.webp)
Setting Up the Multifunction Interface
2 Connect one end of the cable to the port on the Sharp Laser Multifunction. Snap the clips on each side of the port onto the cable connector to secure it.
3 Connect the other end of the cable to the parallel port on the back of your computer.
Note: There is normally no need to change the parallel port setting in your computer's setup (BIOS) program. However, if you find that the Sharp Laser Multifunction fax does not operate well when scanning or printing, you may need to change the setting. In this case select ECP, PS2,
1. Installation
25