Replacing the waste ink bottle (con’t)

*WASTE BOTTLE FULL /NOT INSTALLED

SEE USER GUIDE [ER: 4621]

Procedures

When to replace the waste ink bottle

The waste ink bottle should be replaced when the waste ink bottle is filled with the waste ink.

For cases where the waste ink bottle is full, the LCD will display the Waste Bottle Full message.

The amount of waste ink in the waste ink bottle is measured by the waste ink bottle’s weight. The waste ink bottle tray acts as a scale and must move freely to properly measure the amount of waste ink in the bottle and prevent waste ink over-flow.

Caution: If the printer continues to run without detecting the change in the waste ink bottle’s weight, the waste ink bottle could overflow and contaminate the printer and floor.

Replacement procedures

The steps to replace waste ink bottle are:

1.Locate the waste ink bottle on the right rear side of the printer.

2.Pick up the waste ink bottle and tilt it to remove the bottle from the waste ink bottle tray.

3.Place the waste ink bottle into the disposable plastic bag.

3. Properly dispose of the used waste ink bottle.

4.Set the new waste ink bottle on the waste ink bottle tray. Ensure that the bottle is properly seated on the tray before continuing.

Supplies

31

Page 43
Image 43
Sharp X2 manual Replacing the waste ink bottle con’t, When to replace the waste ink bottle