Siemens A31003-51730-U103-7619 user manual 4.4.4Change the size of Frames and Controls

Operating Instructions for the OScAR-Pro Customized Operator

Setup and application of the Layout window

4.4.4Change the size of Frames and Controls

There are two ways to change the size of a Control:

1.Mark the elements you want to select, press the SHIFT and Ctrl key and keep both keys pressed, and use the arrow keys () to increase or decrease the size of the ele- ment. Each time you press an arrow key the size of the selected elements will increase or decrease in increments of 1 pixel.

2.Mark the element you want to select and move the mouse cursor over one of the 8 black squares of the accented frame. This will change your mouse cursor to:

Position of the black square	Cur-
	sor
Upper left and lower right corner
Upper and lower center
Left and right center
Lower left and upper right corner

Now press the left mouse key, keep the key pressed and change the size as needed in the directions indicated by the mouse cursor.

You can also blend several elements in size.

To do so, mark at least two elements you want to blend in size. Here, the DCO-Designer will usually focus on the first element that is marked. Now go to the menu bar, open "LayoutMake Same Size" and choose the way in which you want to blend the marked elements ("Width", "Height" or "Both"). The elements are now blended in size in keeping with this selection and on the basis of the element that has the focus, usually the one that was marked first.

	07/2010
4-20	OScAR-Pro Customized Operator, User Manual