Siemens SE505 manual 107

	Appendix
Symptom	Possible cause and solutions
No connection to the router's	◆ Use the ping command to check whether you can
configuration environment	establish a network connection to the Gigaset
	SE505 dsl/cable.
	◆ Check the network cable between the PC you want
	to use to administer the router and the Gigaset
	SE505 dsl/cable.
	◆ If the PC you want to use is on the router's local
	network, make sure that you are using the correct IP
	address administration (see above).
	◆ If the PC you want to use is not on the router's local
	network it must be authorised via Remote
	Management.
Password forgotten or lost	◆ Reset the router (see page 108).
	Warning: Please bear in mind that this will restore all
	configuration settings to the factory settings.
You cannot access a resource	◆ Make sure that TCP/IP has been installed and
(drive or printer) on a	configured on all the PC's on the local network and
different PC	that the PC's all belong to the same workgroup.
	◆ Check whether the resource has been released on
	the PC in question and whether you have the
	necessary access rights.
	◆ Printing: Check whether the printer has been set up
	as a network printer.

107