First Steps

Setting up the Gigaset SE505 dsl/cable

The Gigaset SE505 dsl/cable can be set up in any suitable location in the home or office. You do not need any special wiring. However you should comply with the following guidelines:

Operate the Gigaset SE505 dsl/cable only indoors within a temperature range of +5 to +40 °C. Do not position the Gigaset SE505 dsl/cable near a heat source. Do not cover the ventilation slots. High temperatures will reduce the transmitter range.

A mains socket for 220/230V~ and a connection socket for the DSL modem, cable modem or LAN must be available where you set up the Gigaset SE505 dsl/cable.

Do not site the router in the immediate vicinity of stereo equipment, TV sets or microwave ovens as this may cause interference.

Position the Gigaset SE505 dsl/cable so that it is as near to the centre of your wireless network as possible. The general rule is: The higher you place the antenna, the better the performance. Make sure that where you position the Gigaset SE505 dsl/ cable has optimum reception throughout the house or office.

Position the Gigaset SE505 dsl/cable on a non-slip surface.

The router feet do not normally leave any traces on the surface they are on. However, some furniture surfaces may contain substances that attack and soften the router's plastic feet. Then the feet may well mark the furniture surface.

Position the Gigaset SE505 dsl/cable so that it cannot fall down and damage the antenna.

Lay the cables so that nobody can trip over them. You should not cover the cables with anything.

Protect the Gigaset SE505 dsl/cable from moisture.

Installing the Gigaset SE505 dsl/cable

!

Only use the router with the mains adapter (12V 1A) that is supplied.

Do not plug any phone jack connectors into the router WAN and LAN sockets.

Use standard network cables for all connections (CAT-5) for the WAN and LAN connections.

An Ethernet cable must not be longer than 100 metres.

Before you start connecting PC's to your Gigaset SE505 dsl/cable make sure that

a wired or wireless Network adapter is connected to the PC. Please read the operating instructions that came with the adapter. The latest PC's and Notebooks have wired adapters built in at the factory.

ConnectionPoint has been entered as SSID on the network adapter.

13

Page 14
Image 14
Siemens manual Setting up the Gigaset SE505 dsl/cable, Installing the Gigaset SE505 dsl/cable