Siemens X-400 Directive on Machines, Note for the Manufacturers of Machines

Approvals, Certificates

Directive on Machines

The product remains a component in compliance with Article 4 (2) of the EU direc- tive on machines 89/392/EEC.

According to the directive on machines, we are obliged to point out that the product described is intended solely for installation in a machine.

Before the final product can be put into operation, it must be tested to ensure that it conforms with the directive 89/392/EEC.

Note for the Manufacturers of Machines

This product is not a machine in the sense of the EU directive on machines. There is therefore no declaration of conformity for the EU directive on machines 89/392/EEC.

If the product is part of the equipment of a machine, it must be included in the pro- cedure for obtaining the declaration of conformity by the manufacture of the ma- chine.

Installation Guidelines

The products meet the requirements if you adhere to the installation and safety in- structions contained in these Operating Instructions SIMATIC NET Industrial Ethernet SCALANCE X-400 and in the following documentation:

SIMATIC NET Industrial Twisted Pair and Fiber Optic Networks Manual /2/

This documentation is available on the Internet at

http://support.automation.siemens.com/WW/view/en/8763736

!Warning

Personal injury and damage to property may occur.

The installation of expansions that are not approved for SIMATIC NET products or their target systems may violate the requirements and regulations for safety and electromagnetic compatibility.

Only use expansions that are approved for the system.

Operating Instructions for SCALANCE X-400 Industrial Ethernet Switches	133
C79000-G8976-C186-03