Siemens X-400 technical specifications Fitting / Removing a Dummy Cover, Fitting a Dummy Cover

Installation and Commissioning

6.2.3Fitting / Removing a Dummy Cover

Fitting a Dummy Cover

There is only one dummy cover (no port displays connected to the front) on slot 8.

To fit a cover, you do not require any tools.

1.Place the two lower guides of the dummy cover into the recesses at the lower edge of the basic device. It should no longer be possible to move the dummy cover to the side.

2.Tilt the dummy cover at an angle towards the back until the two plastic pins at the back top edge of the dummy cover jut into the recesses in the basic device.

3.Press the upper part of the dummy cover onto the basic device until the fluted middle section of the dummy cover is heard to click into place.

4.Secure the labeling strip on the front of the dummy cover.

Removing a Dummy Cover

To remove a cover, you do not require any tools.

1.Press on the fluted middle section of the top of the dummy cover next to the backplane.

2.At the same time, tilt the dummy cover down at an angle, the two guides ini- tially remain in the recesses at the lower edge of the basic device.

3.Remove the dummy cover by pulling it upwards.

Operating Instructions for SCALANCE X-400 Industrial Ethernet Switches	75
C79000-G8976-C186-03