Installation and Commissioning

Figure 6-1 Installation on an S7-300 rail

Removing from the S7-300 rail

To remove the device, you require a slotted screwdriver with a 5.5 mm wide blade.

Notice

When removing the SCALANCE X414-3E, hold it by the backplane and not by the modules, otherwise the device may be damaged.

To remove the device, follow the steps below:

1.Remove the covers from slots 7 and 9 (see section 6.2.2) and the dummy cover from slot 8 (see section 6.2.3). If media modules are inserted, remove the fast Ethernet media module instead of the cover from slot 7 (see section 6.2.1).

2.Using a screwdriver with a 5.5 mm wide blade, loosen the two captive screws in the backplane at slot 7 and between slots 8 and 9.

3.Pull out the lower part of the basic device slightly towards the front and lift it from the S7-300 rail.

Operating Instructions for SCALANCE X-400 Industrial Ethernet Switches

69

C79000-G8976-C186-03

Page 69
Image 69
Siemens X-400 technical specifications Removing from the S7-300 rail, Installation on an S7-300 rail