Siemens X-400 Removing from the 35 mm Standard Rail, Installation and Commissioning

Installation and Commissioning

Figure 6-2 Installation on a 35 mm standard rail

Removing from the 35 mm Standard Rail

Since the two captive screws in slot 7 and between slots 8 and 9 are not used to secure the device, when removing it from a 35 mm standard rail, it is not absolutely necessary to remove the covers and the blind cover, although this does make it easier to handle the basic device.

Notice

When removing the SCALANCE X414-3E, hold it by the backplane and not by the modules, otherwise the device may be damaged.

To remove the device, follow the steps below:

1.Push the basic device down until the lower part can be pulled away from the standard rail to the front.

2.Lift the SCALANCE X414-3E up and off the standard rail.

Operating Instructions for SCALANCE X-400 Industrial Ethernet Switches	71
C79000-G8976-C186-03