Other Settings (Options)

You can make other operation settings.

On Screen Display

On

Automatically displays

 

information on the screen

 

when the recorder is turned

 

on, etc.

 

 

Off

Displays information only

 

when DISPLAY is

 

pressed.

 

 

2Set the Command Mode for the remote so it matches the Command Mode for the recorder you set above.

Follow the steps below to set the Command Mode on the remote.

1 Hold down ENTER.

2 While holding down ENTER, enter the Command Mode code number using the number buttons.

3 Hold down both the number and ENTER buttons at the same time for more than three seconds.

zHint

You can check the Command Mode for the recorder in the front panel display (page 13). When the Command Mode is set to “3 (Default setting),” “1” or “2” does not appear.

Front Panel Display

Adjusts the lighting of the front panel display.

On

Bright lighting.

 

 

Off

Turns off the lighting and

 

saves power consumption

 

when the power is off.

 

 

Command Mode

Changes the Command Mode of the recorder to avoid interference with your other Sony DVD recorder or player.

1Select a Command Mode (“1,” “2,” or “3 (Default setting)”), and press

ENTER.

bNote

The default command mode setting for this recorder and the supplied remote is “3 (Default setting).”

The remote does not function if different command modes are set for the recorder and remote. Set the same command mode.

SMARTLINK

This Recorder

Allows you to use the

Only

SMARTLINK function

 

with the recorder when the

 

recorder is in standby

 

mode.

 

 

Pass Through

Allows you to use the

 

SMARTLINK function

 

with the connected

 

equipment when the

 

recorder is in standby

 

mode.

 

 

bNote

Set “Standby Mode” to “Mode 2” in the “Basic” setup (page 118) to set “SMARTLINK” to “Pass Through.”

DivX

Registration Code

Displays the registration code of DivX video files for this recorder.

For more information, go to http://

www.divx.com/vod on the Internet.

132