7 Select “Confirm” using </,, and press ENTER.
The display returns to the GUIDE Plus+ setup menu.
8 Wait one day until the programme guide data can be received.
To cancel the settings
Press the red button (“Back”).
To check the GUIDE Plus+ system information
1Select “Setup” in the Menu Bar, and press ENTER.
2Select “GUIDE Plus+ system Information” using M/m, and press
ENTER.
bNote
The GUIDE Plus+ system is reset when you make changes to the host channel settings.
Checking programme positions (Editor)
Check whether programme position numbers are the same as the programme position numbers set in the “Tuner” setup. If you want to make adjustments to the channel settings or change the channel name, see “Aerial Reception Settings (Tuner)” (page 119).
1 Press GUIDE.
2 Press M to move the cursor to the
Menu Bar.
3 Select “Editor” using </,.
“Editor”
4
5 Press , to move the cursor to the right column.
6 Select the programme position you want to check using M/m.
To change the programme position, press the green button (“Prog. No.”), then enter a programme position number using the number buttons, and press
ENTER.
zHint
To receive from the recorder a programme position that can be received by either the set top box receiver or the recorder, change the input source in step 6.
Disabling programme positions (Editor)
If any programme positions are unused or contain unwanted channels, you can hide them.
1 After step 4 of “Checking programme positions (Editor),” in the left column, select the programme position you want to hide or display using M/m.
2 Press the red button (“On/Off”).
The disabled positions will turn grey. To show the disabled positions, press the red button (“On/Off”) again.
bNotes
•You cannot record a programme position if it is not set in “Aerial Reception Settings (Tuner)” (page 119) even if it is set to “On” in the “Editor” in the Menu Bar.
•If you are using your set top box receiver to receive programmes (when the set top box receiver is connected to the recorder using a SCART cord only, page 16) and are able to receive the same programme with both the set top box receiver and the recorder, change the “Source” to receive the programme with the recorder’s tuner.
only)
51