,The
,The timer setting for the connected equipment overlapped the recorder’s timer setting (page 64).
,There was a power failure during the recording.
,The [/1 button was pressed before
The clock has stopped.
,Set the clock again (page 117).
The clock is wrong.
,Set the clock again (page 117). If you cannot set the clock, wait until the clock data is received and the clock is automatically adjusted.
The recorder automatically starts recording when the satellite receiver is turned on.
,The Synchro Rec function was activated. Turn off the satellite receiver and cancel the Synchro Rec function (page 64).
DubbingYou dubbed a title, but the title did not appear in the HDD Title List.
,The title contained a copy protection signal, so it was moved (page 150).
,The title cannot be dubbed at high speed (page 84). Even if
HDD/DVD Dubbing is not possible.
,The title cannot be dubbed (page 83).
HDD camcorder dubbing is not possible.
,An HDD camcorder which is not supported by this recorder is connected (page 87).
,The HDD camcorder is not set to the USB connection mode (page 88).
,The HDD camcorder contains only the contents that have already been dubbed to the recorder when you are dubbing using the
The timer indicator is flashing.
,The disc does not have enough space.
,Insert a recordable disc into the recorder.
,The inserted DVD is protected (page 42).
The clock does not appear in the front panel display when the recorder is turned off.
,“Front Panel Display” is set to “Off” in the “Options” setup (page 132).
Remote controlThe remote does not function.
,Different command modes are set for the recorder and remote. Set the same command mode (page 132). The default command mode setting for this recorder and the supplied remote is “3 (Default setting).” You can check the current command mode in the front panel display (page 132).
,The batteries are weak.
,The remote is too far from the recorder.
,The remote’s manufacturer code returned to the default setting when you replaced the batteries. Reset the code (page 23).
,The remote is not pointed at the remote sensor on the recorder.
OthersThe recorder does not detect a USB device connected to the recorder.
,Make sure that the USB device is securely connected to the recorder (page 133).
,Check if the USB device or a cable is damaged.
,Check if the USB device is on.
140