Viewing images recorded on “Memory Stick”s on your computer

(1) Turn on the power of your computer and allow Windows to load.

(2) Insert the supplied CD-ROM into the CD- ROM drive of your computer. The application software screen appears.

(3) Move the cursor to “USB Driver” and click. This starts USB driver installation.

(4) Follow the on-screen messages to install the USB driver.

(5) Insert a “Memory Stick” into your camcorder, connect the AC power adaptor and set the POWER switch to MEMORY.

(6) Connect the (USB) jack on your camcorder with the USB connector on your computer using the supplied USB cable.

USB MODE appears on the LCD screen of your camcorder. Your computer recognizes the camcorder, and the Windows Add Hardware Wizard starts.

(7) Follow the on-screen messages to make the Add Hardware Wizard recognize the hardware. The Add Hardware Wizard starts two times because two different USB drivers are installed. Be sure to allow each installation to complete without interrupting them.

Beelden van een “Memory Stick” bekijken met uw personal computer

(1) Schakel uw computer in zodat Windows gestart wordt.

(2) Plaats de bijgeleverde CD-ROM in het CD-ROM station van uw personal computer. Het beginscherm van het toepassingsprogramma verschijnt.

(3) Plaats de cursor op de regel “USB Driver” en klik hierop. Het installeren van het USB stuurprogramma begint.

(4) Volg de aanwijzingen die tijdens de installatie van het USB stuurprogramma op uw scherm verschijnen.

(5) Plaats een “Memory Stick” in uw camcorder, sluit de netspanningsadapter aan en zet de POWER schakelaar in de “MEMORY” stand.

(6) Verbind de (USB) aansluitbus van uw camcorder met de USB-aansluitbus van uw personal computer met behulp van de bijgeleverde USB-kabel.

De aanduiding “USB MODE” verschijnt op het scherm van uw camcorder. Uw personal computer herkent nu de camcorder en het Windows Nieuwe Hardware Wizard hulpprogramma voor het toevoegen van nieuwe apparatuur neemt het over.

(7) Volg de aanwijzingen op het scherm om te zorgen dat het Nieuwe Hardware Wizard programma de apparatuur herkent. Het Nieuwe Hardware Wizard hulpprogramma voor het toevoegen van nieuwe apparatuur zal tweemaal gestart worden, omdat er twee verschillende USB stuurprogramma’s worden geïnstalleerd. Onderbreek de installatie niet halverwege, maar volg alle instructies voor een volledige installatie.

(USB) jack/

(USB) aansluitstekker

USB connector/

USB-aansluitbus

196

USB cable/USB-kabel