Location and Function of Parts

Front Panel

Overview 1 Chapter

6OPEN switch

5POWER switch

4Monitor display section (see page 16 (GB))

4LCD protection board installation screw hole (bottom of unit)

3Carrying handle

1 Cassette lid

1Display window (see page 11 (GB))

2Tape transport control section (see page 13 (GB))

2 RESET button (bottom of unit)

3Audio control section (see page 15 (GB))

1Cassette lid

To open the cassette lid, slide the OPEN switch 6 to OPEN. The lid will click open. Raise the lid and insert a cassette.

For details of usable cassettes, see “Notes on Video Cassettes” on page 40 (GB).

2RESET button

Press this button (bottom of unit) to initialize the internal clock, all menu items and the time code of the FREE RUN setting. Press this button with the tip of a ball-point pen or similar tool.

3Carrying handle

Use the handle to carry the unit.

4LCD protection board installation screw hole Use this hole to install the LCD protection board (supplied).

5POWER switch

Push up this switch to ON to turn on the power.

Note

Power to the camera cable is not interrupted even if this switch has been turned off. If you are not going to use the camera, turn off the power of the camera, disconnect the camera cable and the DSR-50/50P AC adaptor, or remove the battery pack.

6OPEN switch

Slide this switch to the right (OPEN) to open the cassette lid 1.

10 (GB)

Chapter 1 Overview