To video equipment without a DV jack (when using the DSR-50/50P as a player)

You can connect this unit to video equipment without a DV jack. Use this unit as a player as follows.

The following shows an example configuration of dubbing a tape with its time code in the externally-synchronized playback mode. In this configuration, the recorder is a VCR equipped with component input connectors.

Monitor

75 Ω coaxial cable (not supplied) DSR-50/50P (player) (right panel)

to the audio input jack

Preparations 2 Chapter

Reference signal generator

to the video input connector

SG

75 Ω coaxial cable (not supplied)

to the

to the B.B.OUT connector

B.B.OUT connector

75 Ω coaxial cable (not supplied)

Phono jack cable (not supplied)

to the REF.VIDEO connector

recorder

to the time code input connector

to the

to the

75 Ω

coaxial cable

audio

component input

(not supplied)

input

connectors

 

 

connectors

Video cable (3BNC y 3BNC) (not supplied)

 

 

 

 

 

 

Conversion cable (XLR y phono) (not supplied)

Amplifier (as needed)

 

: Signal flow

Notes

•If you connect the input connectors of this VCR to the output connectors of the monitor or recorder, a humming noise may be generated or the image may be distorted.

•Text data (time code, warnings, menus, etc.) are superimposed only on the signal sent to the VIDEO OUT1 output.

•To play back synchronized with the reference video (black burst) signal, set the EXT SYNC on the VIDEO SET menu to ON.

Chapter 2 Preparations

39 (GB)