Adjusting the Signals

You can adjust each signal level of the component output signal and the chrominance signal gain level of the composite signal.

Connect the reference video (black burst) signal one- to-one with a device that generates the reference video signal, or make a loop-through connection. If the device has a terminal switch, terminate the connection properly.

You need both a waveform monitor and a vectorscope to display the component signals.

Adjusting the Output Level

Notes

•If you adjust the component signal level, be sure to adjust the chrominance signal gain level of composite signals.

•Adjust the output level while playing the tape. Adjust the input level in the EE mode.

•You cannot adjust the signals input to the DV IN/ OUT connector. You cannot adjust the signals output from the DV IN/OUT connector during playback.

DSR-50/50P

Waveform monitor

Vectorscope

 

 

Composite

Composite

Composite

VIDEO OUT2

video input

video output

video input

 

Component

 

 

COMPONENT OUTPUT

input

 

 

and Code Time the Setting 4 Chapter

Adjusting the component signal level

1 Play back a tape and output the signals from the Y, R-Y and B-Y connectors of the COMPONENT OUTPUT connectors.

The waveform monitor displays the picture.

2 Adjust the Y, R-Y, and B-Y signal levels in PB OUTPUT in VIDEO LVL on the VIDEO SET menu.

Y LVL: Adjusts the Y signal level.

R-Y LVL: Adjusts the R-Y signal level.

B-Y LVL: Adjusts the B-Y signal level.

For details on “PB OUTPUT”, see “VIDEO SET menu” on page 85 (GB).

Signals Video the Adjusting

Chapter 4 Setting the Time Code and Adjusting the Video Signals 67 (GB)