3

Operating Mode

 

 

The preselection of the device functions are carried out by choosing the operating modes 0...5 according to the following table, see chapter 3.1, (EASYRIDER→ Windows - Software).

Each operating mode allows the assignment of different in- and output functions (F0..F6).

Operating

Reference-source

 

Hints for selecting the operating

mode

 

 

 

0

analog (X10.5/18)

 

switchable the operating modes 1 and 2 by input X10.24

1

 

 

speed control analog

 

 

torque controller analog

2

 

 

 

 

 

3

analog (X10.5/18) /

 

simple applications with requirement of switching between

 

digital

 

position and speed control position controller (input X10.24)

 

 

 

handling like operating mode 4

 

 

 

 

4

digital or analog in acc.

 

general position-controlled systems. Up to 10 positions can be

 

to parameter set

 

stored under identifier-numbers and activated like shown.

 

 

 

 

5

digital or analog in acc.

 

simple to complex systems using instructions BIAS

 

to programming or via

 

(up to 1500 command blocks)

 

digital communication

 

PLC - functions

 

(e.g. fieldbus)

 

for further information:

 

 

 

see chapter 13.1 and 13.2

________________________________________________________________________________________________________________________________________________________________________________________________________________________

46

Product Manual Type: 637f

07-02-10-01-E-V0505.doc