
Chapter 4 Using Your Motion Tablet PC
Launching Stand by or Hibernate Modes from the Start Button
1.Select Start>Shut Down.
2.From the
3.The Tablet PC will then enter Stand by or Hibernate. In Stand by, the power LED flashes green. In Hibernate, all the status LEDs are off.
IMPORTANT: You can put the Tablet PC in either Stand by or Hibernate to swap the battery. See the section “Swapping the Battery” in this chapter.
Launching Stand by Mode from the Motion Dashboard
Open the Motion Dashboard and then tap the Stand by button.
Setting Up Stand by or Hibernate Modes from the Power Switch
When you slide the power switch, by default your Tablet PC shuts down.
You can change this setting so that you can enter either Stand by or
Hibernate from the power switch.
1.Open the Motion Dashboard.
2.On the Dashboard, under Power Management, tap the down arrow by the Pwr Button.
3.From the
4.Select OK.
Restarting from Stand by or Hibernate Modes
To restart from Stand by or Hibernate, briefly slide the Power switch until the Tablet PC display turns on. Tap your user name to resume work.
OPERATING THE The Motion digitizer pen contains internal
MOTIONelectronics that let you enter digital ink on the
DIGITIZER PEN Tablet PC display.
clicking (like a mouse) and a small opening near the end for attaching it to the pen tether. The pen also comes with replacement pen tips and a replacement tool, shown here. For information about replacing the pen tips, see “Replacing the Pen Tips” in this chapter.
Notations for using the Motion pen are described below:
•Tap — Firmly tap the pen on the Tablet PC display, without pressing the function button on the pen
•
•