Chapter 4 Using Your Motion Tablet PC
NOTE: These procedures describe using the pen to enter information; you can also attach an external keyboard if you prefer.
1.Start the Tablet PC.
2.When the Motion Computing Splash Screen appears, quickly press Hot Key #2 (icon shown here). If you miss the Splash screen, turn the Tablet PC off then back on and try this step again.
3.From the PhoenixBIOS Setup Utility, tap Security on the menu bar.
4.To set up a System password,
5.Type in a System Password using the onscreen keyboard.
6.Tap Enter.
7.Type in the password again to confirm it.
8.Tap Enter. The system returns to the Security screen and the System Password reads Set. A password is now required to enter the PhoenixBIOS Setup Utility.
9.To set up a Password on boot, tap Disabled next to Password on boot until Enabled is highlighted. You will not be prompted to type in another password because Password on boot uses the System password.
NOTE: You cannot set up Password on boot until you set up a System password.
10.If you have finished setting up a password, tap Exit or press the Esc key on the Tablet PC to exit the PhoenixBIOS Setup Utility.
11.When you exit, you are prompted to select from the following options:
•Exit Saving Changes
•Exit Discarding Changes
•Load Setup Defaults
•Discard Changes
•Save Changes
12.Select the desired action.
13.Confirm the selection by tapping Yes.
Hard Disk Drive (HDD) Password
To set up a password to start the Tablet PC (so no one can access the information on the Hard Disk Drive of your Tablet PC even if it is removed and installed in another Tablet PC without the proxy password):
1.Start the Tablet PC.
2.When the Motion Computing Splash Screen appears, quickly press Hot Key #2. If you miss the Splash screen, turn the Tablet PC off then back on and try this step again.
3.From the PhoenixBIOS Setup Utility, tap Security on the menu bar.
