Chapter 4 Using Your Motion Tablet PC

SAVING

BATTERY

POWER WITH

THE AMBIENT

LIGHT SENSOR

ADDING

MEMORY TO

IMPROVE

SYSTEM

PERFORMANCE

Under certain lighting conditions, when the Ambient Light Sensor is enabled, it may automatically dim the display back light, thus saving battery power. The power savings depends on a combination of the ALS setting (on the brightness slider) and the ambient light in the environment.

NOTE: For optimal battery life benefits and viewability, we recommend that you set the brightness slider to the mid-point or slightly above or below mid-point. If you set the slider higher than this, you lose some of the battery-saving benefits, while gaining minimal improvement in viewability.

Use only Motion memory modules obtained from Motion Computing to upgrade the factory-installed memory.

Supported Memory Configurations M1400

Base Memory-Slot A**

Base Upgrade-Slot B**

Total Memory

 

 

 

256MB

256MB

512MB

 

 

 

 

1GB

1.2GB

 

 

 

512MB

512MB

1GB

 

 

 

 

1GB

1.5GB

 

 

 

1GB

256MB

1.2GB

 

 

 

 

512MB

1.5GB

 

 

 

 

1GB

2GB

 

 

 

NOTE: The Motion M1400 has its base memory factory-installed in Slot A. If you install/reinstall only a single memory module, always install it in Slot A for best performance.

WARNING: When performing the following tasks, turn off your Tablet PC, unplug the AC power connection, and remove the battery. Ground yourself by touching a grounded conductive surface, such as a device or appliance with a grounded, three-pronged plug. Avoid touching the pins and leads on the memory module and the internal circuitry of the Tablet PC.

1.After you disconnect power, unscrew the L-shaped cover from the bottom of the Tablet PC.

2.If you are replacing a module, release the clips on each side of the module and lift to remove it.

3.Align the pins on the Memory Upgrade module with the receptors on the slot.

4.Gently push the new module into the slot at a

25-degree angle until it is firmly seated; then rotate it into place.

5.Replace the external cover and install the two screws.

Motion Computing M1400 Tablet PC User Guide 44

Page 51
Image 51
StarTech.com M1400 manual 1GB