8. Press the Power button (Figure
FIGURE 2-3 Power Switch and Front Panel Detail
Network Setup and System
Configuration
For a detailed explanation of network setup and system configuration, refer to the Software Installation, Configuration, and User Guide "Introduction" on the documentation CD.
If DHCP is supported, the IP address is automatically configured when you power the system up for the first time.
Note – Write down the IP address for use in system configuration.
Network Setup without DHCP
If your network does not support DHCP, you must manually configure the IP address using the NAS filer LCD panel controls by pressing the Select button once, selecting Set Static IP, and selecting or specifying the required information and saving the settings.
Chapter 2 Turning the Sun StorEdge 5210 NAS On and Off 7
