Sun Microsystems X6240 manual To Shut Down Main Power Mode

▼To Shut Down Main Power Mode

To power off the server module from main power mode, use one of the following two methods:

■Graceful shutdown. Use a ballpoint pen or other stylus to press and release the Power button on the front panel. This causes Advanced Configuration and Power Interface (ACPI) enabled operating systems to perform an orderly shutdown of the operating system. Servers not running ACPI-enabled operating systems will shut down to standby power mode immediately.

■Emergency shutdown. Press and hold the Power button for four seconds to force main power off and to enter standby power mode.

When main power is off, the blue (Ready to Remove) LED on the front panel will be illuminated, indicating that the server module is in standby power mode.

Note – To power off the server module completely, you must disconnect the AC power cords from the back panel of the chassis. This will remove power from all the blades in the chassis.

Chapter 1 Setting Up the Server Hardware 7