Installing the Server Module Into the Chassis

Consult the following sections when installing a server module into a powered on chassis:

“Before You Begin” on page 34

“Install Server Module Into a Powered-On Chassis” on page 35

Before You Begin

Prior to installing the server module into a powered-on chassis, ensure that the following requirements are met.

Ensure that the following chassis components are installed and powered-on in the Sun Blade 6000 or 6048 Series Chassis.

Chassis monitoring module (CMM).

Network express modules (NEMs)

All required cabling to the chassis are attached.

The system chassis is powered-on.

For information about installing chassis components, attaching cables, and powering on the chassis, see the Sun Blade 6000 or 6048 Series Chassis documentation at:

http://docs.sun.com/app/docs/prod/blade.srvr#hic

Review the required installation tasks for properly installing and setting up the Sun Blade X6270 Server Module in the Sun Blade 6000 or 6048 Series Chassis documentation.

For more information, see TABLE 1-4.

If applicable, install the following optional server module components prior to installing the server module into the system chassis:

FEM, REM, DIMMs, and CPU

For instructions, see Chapter 2.

Use a grounded antistatic wrist strap or equivalent safety equipment to prevent electrostatic discharge (ESD) when you install the Sun Blade server module into the system chassis.

34 Sun Blade X6270 Server Module Installation Guide • December 2009

Page 46
Image 46
Sun Microsystems X6270 manual Installing the Server Module Into the Chassis, Before You Begin