
Chapter 6: Advanced Chassis Setup
DVD-ROM and Floppy Drive Installation
The top cover of the chassis must be opened to gain full access to the
You must power down the system before installing or removing a floppy or
With the chassis cover removed, unplug the power and data cables from the drive you want to remove. Then locate the locking tab at the rear of the drive. It will be on the left side of the drive when viewed from the front of the chassis. Pull the tab away from the drive and push the drive unit out the front of the chassis. Add a new drive by following this procedure in reverse order. You may hear a faint *click* of the locking tab when the drive is fully inserted. Remember to reconnect the data and power cables to the drive before replacing the chassis cover and restoring power to the system. Please be aware of the following:
•The floppy disk drive cable has seven twisted wires.
•A color mark on a cable typically designates the location of pin 1.