
SUPERSERVER
Figure 6-5. Removing/Replacing the Power Supply
Reconfiguring the Power Supply
Although the standard configuration for the
Note: in the following instructions, "right" and "left" refers to the side noted when viewed from the rear of the system.
Reconfiguring the 6014P-8/6014P-82 (see Figure 6-6)
1.You will first need to power down the system and remove the power cord. To gain access to the inside of the system, pull the server out from the rack and remove the top chassis cover by following the instructions on page
2.Remove any expansion card that may be installed in the
3.Remove the three screws that secure the riser card bracket, which runs from the primary ATX power connector to the rear of the chassis. After the screws are removed, lift the riser card bracket out from the chassis.