Operating the Equipment Locally
Page 4-98 Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
NOTE…
If Intelligent mode is selected, the Action On PID Error option (see page 4-30) in the
Setup/System/Advanced Menu must be set to Auto Correct. If Dumb mode is selected, the
Action On PID Error option must be set to Raise Alarm.
Packet Length Option
This option indicates the packet length. See Section This option indicates
the packet length. See Section 4.12.4, Packet Length Option for details.
Bit-rate Option
This option indicates the bit-rate. See Section 4.12.6, Bit-rate (188) and
Bit-rate (204) Option for details.
Status Only Options for the Remux Module Menu
The following options are status only and cannot be changed.
· Spare Bit-rate
· Input Bit-rate
· Output Bit-rate
· Host TS Output Rate
· Host Data Rate
· Input TS 1 (188)
· Data Rate 1 (188)
· Input TS 2 (188)
· Data Rate 2 (188)
· Input TS 3 (188)
· Data Rate 3 (188)
· Software Release
NOTE…
The maximum input bit-rate allowed on the Remux Module ASI inputs is 50 Mbit/s. If the input bit-rate
exceeds 86 Mbit/s it will be incorrectly reported as a lower rate.
4.13.4 1.Service/2.Service Menu
Output Option
To access the Output option, press the Remux Mode softkey in the
1.Service Menu14.
14 This name changes to be the same as the Service Name. There could be more menus, depending upon the number
of inputs to the Remux card.