Installing the Equipment
Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Enco d er Page 2-5
ST.TM.E10076.3
Figure 2.1: Fitting the Encoder into a Rack
2.3.2 Cable Routing
Power supply cables should be routed so that they are not likely to be
walked on or pinched by items placed upon or against them. Pay particular
attention to cables at plugs, convenience receptacles, and the point where
they exit from the appliance.
Do not run ac power cables in the same duct as signal leads.
2.3.3 Equipment Access
WARNING...
BERYLLIUM COPPER FINGER STRIPS ARE USED IN THIS EQUIPMENT TO SEAL THE
ENCLOSURE FOR EMI PROTECTION. THIS ARRANGEMENT IS PERFECTLY SAFE DURING
NORMAL OPERATION. DO NOT FILE THE STRIPS OR OTHERWISE CAUSE THEM TO PRODUCE
DUST OR PARTICLES. ANY CUTS CAUSED BY THE STRIP SHOULD BE TREATED
APPROPRIATELY.
Ensure that the Enc oder is installed in such a way as to allow access to the
rear of the unit and the connectors.
2.3.4 Ventilation
WARNING...
NEVER PUSH OBJECTS OF ANY KIND INTO THIS EQUIPMENT THROUGH OPENINGS AS THEY
MAY TOUCH DANGEROUS VOLTAGE POINTS OR SHORT-OUT PARTS THAT COULD RESULT IN
A FIRE OR ELECTRIC SHOCK. NEVER SPILL LIQUID OF ANY KIND ON THE PRODUCT.
CAUTIONS...
1. Openings in the cabinet are provided for ventilation and to ensure reliable operation of the product
and to protect it from overheating, and these openings must not be blocked or covered. This product
should never be placed near or over a radiator or heat register. This product should not be placed in
a built-in installation such as a rack unless proper ventilation is provided or the instructions have
been adhered to.
2. Do not install equipment so that the air intake of one aligns with the outlet on another. Provide baffles
and adequate spacing.
3. The fans contained within this unit are not fitted with a dust/insect filter. Pay particular attention to the
environment in which it is to be used.
Location of screws to attach
Encoder to rack.
Same at the opposite side of
the Encoder.