Operating the Equipment Locally
Page 4-64 Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
Low Pass Filter Option
NOTE…
This option is only shown when the Coding Standard is Dolby Digital (AC-3).
To access the Low Pass Filter option, press the Low Pass Filter softkey in
the Audio A Menu. This parameter is used to activate a low-pass filter with
a cut-off near the specified audio bandwidth that is applied to the main
input channels. The option can be turned On or Off.
Embedded 1-2 DID Option
To access the Embedded 1-2 DID option, press the Embedded 1-2 DID
softkey in the Audio A Menu. Refer to Annex G, Audio Modes for
information about DIDs.
Table 4.61: Embedded 1-2 DID Options
Selected Option Description
Min: 0
Max: 1023
Other: >1023
Off
Select DID
Default DID
Embedded 3-4 DID Option
The Embedded 3-4 DID option is selected from the Audio A Menu by
pressing the Embedded 3-4 DID softkey. The Embedded 3-4 DID option
has the same choices as the Embedded 1-2 DID option.
Audio PID Option
The Audio PID option is selected from the Audio A Menu by pressing the
Audio PID softkey. The option is used for entering or updating audio
PIDs. Enter a PID using the softkeys, then press the Enter softkey to
accept it.
To be DVB compliant, PIDs below 32 are reserved. Therefore PIDs 32 to
8191 are available for use. In the event o f a clash, one of the PIDs w ill be
changed by the Encoder’s internal checking algorithm.
NOTE…
Although PIDs below 32 are reserved it is still possible to change them. However, in the event of a
clash one of the PIDs will NOT be changed by the Encoder’s internal checking algorithm.
Hardware Release Option
This option indicates the hardware release of the audio. It is for status only
and cannot be changed.
Software Release Option
This option indicates the software release of the currently selected audio
standard. It is for status only and cannot be changed.