Tandberg Data Tandberg LTO2 manual Operation, Removal of the Magazine

Chapter 3 Operation

In this chapter, a description is provided of the operation methods that should be known for the daily use of the Autoloader as well as information about the LCD indications.

3.1 Removal of the Magazine

Follow the procedure described below to remove the magazine from the Autoloader.

1. Check that the power of the Autoloader is ON.

Tip

The Autoloader has a double locking mechanism comprising a door lock and an electronic lock. When the power is in the OFF condition, the electronic lock is activated by a solenoid and the door cannot be opened. When it is necessary to open the door while the power is in the OFF condition, use the emergency release key that has been supplied. See “3.8 Using the Emergency Release Key” for information describing the use of the emergency release key.

2.Use the door lock key supplied with the main unit to release the door lock, then open the front door.

Tip

The Autoloader is designed so that the electronic lock operation will again be activated if the front door is not opened within 10 seconds following the release of the door lock with the door lock key. Should the door become locked again, follow this same procedure to release the door lock and then open the front door within 10 seconds.

3.Refer to the diagram affixed to the inside of the front door and press down on the lock lever located at the lower left to release the magazine lock (see figure 3-1).

4.Pull out the magazine that has protruded (see figure 3-2).

Figure 3-1 Lock Lever Figure 3-2 Pulling out the Magazine

- 14 -