5.1.2 Cleaning the Roller inside of the transporter

When the Alarm LED is blinking and "REQ CLNROL" message is displayed on the LCD, the Autoloader is requiring to clean the Roller inside of the transporter, hereafter called CLNROL-function.

As been described above, this Autoloader will teach you the time when it cleans automatically. But if you prefer not to use this function, it is possible to change the setting.

The Autoloader must be in maintenance mode to check or change the setting of this function.

5.1.2.1 Checking the CLNROL- function

The method of checking the CLNROL-function is described in this section.

Default CLNROL-function setting : Enable

Operation 1 Switch ON the power and wait for the completion of power-on test.

Display: READY and DRV empty are alternately displayed.

Operation 2 Press the ENTER key.

Display: STATUS

Operation 3 Press the arrow key and select the MAINTENANC command

Display : MAINTENANC

Operation 4 Press the ENTER key and define the command.

Display (line 1): PASSWORD

Display (line 2): 0000000000

Tip

If you press the allow key, the number is up or down. If you press the enter

key, the number is decided and the cursor move to the next digit. If you have made a mistake, press the escape key. All number you have entered are canceled.

Operation 5 In this condition, press the ENTER key and set the above password.

Display (line 2): RCLN MODE?

Operation 6 Press the ENTER key and define the command.

Display (line 2): View?

- 39 -

Page 55
Image 55
Tandberg Data Tandberg LTO2 manual Cleaning the Roller inside of the transporter, Checking the CLNROL- function